Place of Origin: Jiangsu, China (Mainland) Model Number: CPF-30CX-10 Certification: ISO9001, CE Marked EINECS No. 233-162-8 CAS NO. 10049-04-4 Control: Manual / linkage Installation: Wall-mounted or vertical Power: 220V Main parameters:1. Operating voltage: AC220V plus or minus 20%2. Working temperature: -5 ~ 50 degrees Celsius 3. Relative humidity: 80% 4. Maximum pressure of water-pipe-line: <0.7Mpa 5. There should be no strong electromagnetic field interference around the equipment. 6. Function: Manual / Linkage Low liquid level alarm function Timing start / stop function Alarm remote transfer
5 NaClO2 + 4HCl = 4ClO2 + 5NaCl + 2H2O NaClO2: industrial sodium chlorite (purity≥78% ) or liquidActivator: industrial first grade compound hydrochloric acid (purity≥31%) or other weak acid or strong acid Process principle: Two raw chemicals of NaClO2 and HCl are to be inhaled into the reactor proportionally by two metering pumps, in which produce quantitative high-purity concentrated ClO2 solution, and then to be dosed directly in the water tank or pressured water pipe together with the dilution water.
The highest outlet pressure of ClO2solution is 0.40Mpa. Raw chemicals conversion rate is higher than 90%. The dosage of ClO2 can be adjusted manually or automatically by receiving 4-20mA signal sent by Flow rate of Residual ClO2sensor.
Place of Origin: Jiangsu, China (Mainland) Model Number: CPF-30CX-10 Certification: ISO9001, CE Marked EINECS No. 233-162-8 CAS NO. 10049-04-4 Control: Manual / linkage Installation: Wall-mounted or vertical Power: 220V Main parameters:1. Operating voltage: AC220V plus or minus 20%2. Working temperature: -5 ~ 50 degrees Celsius 3. Relative humidity: 80% 4. Maximum pressure of water-pipe-line: <0.7Mpa 5. There should be no strong electromagnetic field interference around the equipment. 6. Function: Manual / Linkage Low liquid level alarm function Timing start / stop function Alarm remote transfer
5 NaClO2 + 4HCl = 4ClO2 + 5NaCl + 2H2O NaClO2: industrial sodium chlorite (purity≥78% ) or liquidActivator: industrial first grade compound hydrochloric acid (purity≥31%) or other weak acid or strong acid Process principle: Two raw chemicals of NaClO2 and HCl are to be inhaled into the reactor proportionally by two metering pumps, in which produce quantitative high-purity concentrated ClO2 solution, and then to be dosed directly in the water tank or pressured water pipe together with the dilution water.
The highest outlet pressure of ClO2solution is 0.40Mpa. Raw chemicals conversion rate is higher than 90%. The dosage of ClO2 can be adjusted manually or automatically by receiving 4-20mA signal sent by Flow rate of Residual ClO2sensor.
Our main products are 2-chemical and 3-chemical chlorine dioxide generators; gas chlorine dioxide NOX destruction systems; electrolytic sodium hypochlorite generators, and chemical dosing skids.
